ENFORCER SK-1011-SDQ - Keypad Indicators and Sounds; LED Indicators; Keypad Sounds and Amber LED

19
ENFORCER Access Control Keypad
SECO-LARM U.S.A., Inc.
3. In programming mode, clear the auto-disable time:

4. Temporarily pause or resume the auto-disable time:

5. Activate the output during the auto-disable time (i.e. open the protected door):

Programming the Auto-Disable Time (continued):
Programming the Wrong-Code System Lock-Up:
The keypad can be programmed to lock up in order to secure the premises against unauthorized
entry if multiple wrong codes are entered.
When programming the wrong-code system lock-up, use this general formula:
DD

±3URJUDP:URQJ&RGH6\VWHP/RFN8S
$$
±/RFN2SWLRQV
Lock Options:
Choose from several different options for the wrong-code system lock-up security level:
•

– After 10 successive false attempts using incorrect user codes, the keypad will lock for 60
seconds (default).
•

to

– After 5 to 10 successive false attempts using incorrect user codes, the keypad
will lock for 15 minutes or until the super user code is used as follows:
SUPER USER CODE

•

±1RV\VWHPORFNXSZLOOKDSSHQ
NOTE 7KHNH\SDG¶VUHG/('ZLOOUHPDLQOLWWRVKRZWKDWWKHNH\SDGLVORFNHG
Programming the User Code Entry Mode:
The keypad can be programmed for auto or manual user code entry modes:
• $XWRHQWU\PRGH±3UHVVLQJWKH

NH\LVQRWUHTXLUHGDIWHUW\SLQJLQDXVHUFRGH,QDXWRHQWU\
mode, all user codes must have the same number of digits as the master code.
• 0DQXDOHQWU\PRGH±7KH

key must be pressed after the user code to indicate the code has
been entered completely. In this case, the user codes can have a different number of digits, from
4 to 8 digits.
6
ENFORCER Access Control Keypad
SECO-LARM U.S.A., Inc.
LED Indicators and Keypad Sounds:
Keypad Sounds and Amber LED
Status Sounds
(1)
Amber LED (Center)
In programming mode – 6WHDG\21
Successful key entry %HHS 1 Flash
Successful code entry %HHSV 2 Flashes
Unsuccessful code entry %HHSV 5 Flashes
Power up delay Continuous beeping &RQWLQXRXVÀDVKLQJ
Output relay activation
(2)
1-Sec long beep –
In standby mode
(3)
– )ODVKVHF
System restore mode %HHSV )DVWÀDVKLQJIRUPLQ
Code already stored /RQJEHHS –
Real-time clock stopped after
power loss
Continuous 3 fast beeps
every 5 seconds
–
NOTE:
1. .H\SDGVRXQGVFDQEHSURJUDPPHG21RU2))VHHSDJH
2. Output relay activation sounds can be programmed for 1-sec long beep, 2 short beeps, or OFF
(see page 20).
3. $PEHU/('ÀDVKLQJGXULQJVWDQGE\PRGHFDQEHSURJUDPPHG21RU2))
(see page 21).
LED Indicators
Red LED (Left) Amber LED (Center) Green LED (Right)
Steady Output inhibited 3URJUDPPLQJPRGH Output activated
Flashing Output inhibit paused Standby mode –