ENFORCER SK-1011-SDQ - Sample Applications

17
ENFORCER Access Control Keypad
SECO-LARM U.S.A., Inc.
Programming the Real-Time Clock:
A 24-hour real-time clock provides the baseline time needed to start and stop the output auto-
GLVDEOHWLPHVHH³3URJUDPPLQJWKH$XWR'LVDEOH7LPH´RQSDJHVa
If the auto-disable time is not programmed, it is not necessary to set the real-time clock.
To set the clock, use this general formula:
++00

±3URJUDP5HDO7LPH&ORFN
++
– Hours
00
±0LQXWHV
Setting Hours and Minutes:
•
++
represents hours and
00
represents minutes in the military (24-hour) time format,
from 00:00 to 23:59.
Examples:
1. 6HWWKHUHDOWLPHFORFNWR$0

2. 6HWWKHUHDOWLPHFORFNWR30

NOTE:
• If the auto-disable time is programmed, losing power will cause the keypad to beep 3 times
every 5 seconds. To deactivate this alert, either reset the real-time clock or clear the auto-disable
time.
• If the auto-disable time is not programmed, losing power will not cause the keypad to beep.
• 7RHQVXUHDFFXUDWHWLPHLWLVDGYLVHGWRUHSURJUDPWKHUHDOWLPHFORFNHYHU\WKUHHWRVL[PRQWKVDQG
ZKHQ'D\OLJKW6DYLQJV7LPHEHJLQVDQGHQGVLIDSSOLFDEOH
SK-1011-SDQ
OUTPUT 1
N.C. COM N.O.
(+) (-)
12~24V AC/VDC
EG
IN
TAMPER
N.C.
Connection terminals
8
ENFORCER Access Control Keypad
SECO-LARM U.S.A., Inc.
Connection Terminals
Terminal Description
7DPSHU1&
7DPSHUVZLWFKRXWSXW1&FRQWDFWPD[
P$#9'&&RQQHFWWRWKH1&KRXU
protection zone of an alarm if needed.
a9$&9'&
&RQQHFWWRDa9$&9'&SRZHUVXSSO\
Observe polarity.
2XWSXW1&
121&&20UHOD\RXWSXW
PD[$#9'&
2XWSXW&20
2XWSXW12
(JUHVV,QSXW
123XVKEXWWRQFRQWDFWWRJURXQG3UHVV
button to initiate door unlock output
Wiring Diagram:
Sample Applications:
Stand-Alone Door Lock:
In this application, the keypad is connected to a single door lock and an egress pushbutton.