EasyManua.ls Logo

ENGWE MTB26 - Charging

Default Icon
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6
Charging
●When charging the bicycle, just plug the charger into the bicycle battery. Note: The
plug hole is located in the left of the battery.
●You can charge the bike directly, or you can remove the battery for charging.
●The RED light indicates it is in charging and GREEN light indicates the battery is
fully charged. (Please put off plug from wall) Usually the charging time is 4-6 hours
depends on the battery capacity remain.
WARNING:
●Charging time over 10 hours is prohibited please kept it away from high
temperature environment and stores it in a cool place.
●Please make sure that the battery charger and charging plug are always kept dray
and never get wet.
●The charger should only be cleaned with a dry cloth. Never use a wet cloth, oil or
any other liquid.
●Do not connect positive and negative terminals.
●Stop the charging procedure immediately if you notice anything unusual.
●It is strictly forbidden to cut the battery charging and discharging lines.
●It is strictly forbidden to disassemble the battery box or modify the internal structure
and protection board of the lithium battery.
●Only use the ENGWE supplied charger. Do not use a charger from any other
different product models.
●After using the battery, please charge it within 12 hours.

Related product manuals