ENSIM SENSORS EFS User Manual

3
1.4.
Technical Specifications and Material
Technical Specifications :
MODEL
Plastic Type (EFS ..p)Stainless Type (EFS ..s)
AISI 304 St.St. (Opt. AISI 316 St.St.)
Body+Thread+Nut
Polypropylene
MATERIAL
Relay Case
Polypropylene
Polypropylene
Bolt
Polypropylene
AISI 316 Stainless Steel
AISI 316 Stainless Steel
Polypropylene
Palette
Polypropylene
T Body
Magnet Case
Polypropylene
Polypropylene
FPM
O-Ring
NBR
FLUID
TOLERANCE
MAX. WORKING PRESSURE
WORKING TEMPERATURE
25 bar 10 bar
+/- %15 of full scale value
Water
(Oil, gas and aggresive media on request)
+/- %15 of full scale value
Water
(Oil, gas and aggresive media on request)
(-) 20 °C / (+) 110 °C (-) 20 °C / (+) 70 °C
AMBIED TEMPERATURE
(-) 20 °C / (+) 70 °C (-) 20 °C / (+) 70 °C
CONTACT
Reed Switch SPST - NO
* MAX. CONTACT POWER
* MAX. SWITHCHING VOLTAGE
PROTECTION CLASS
Opt.Cable Output, Socket with LED
ISO 4400 socket
ELECTRICAL CONNECTIONS
Opt.Cable Output, Socket with LED
IP 65, IP 67 (for sx, cx type) IP 65, IP 67 (for px, bx type)
* CONTACT CURRENT
200 VDC / 140 VAC
1 A
200 VDC / 140 VAC
1 A
10 W / VA 10 W / VA
Reed Switch SPST - NO
AISI 304 St.St. (Opt. AISI 316 St.St.)
ISO 4400 socket
Palette
T Body
Body
Relay Housing
Allen Thread
Nut
Seal
Socket
Housing
Adjusting
the switching unit
To open
FLOW
Palette
Thread
Body
Relay Housing
Allen Thread
Seal
Socket
Housing
Nut
FLOW
Adjusting
the switching unit
To open
It must be ensured that the values given for voltage, current, and power are not exceeded.
When switched on, a load must be connected in series.
The electrical details apply to ohmic loads.
(Capacitive or inductive loads must be operated using a protective circuit.)
Please pay attention to following matters in order to operate your flow switch properly.
WARNINGS!
*
-
-
-

ENSIM SENSORS EFS Specifications

General

Brand	ENSIM SENSORS
Model	EFS
Category	Switch
Language	English