ENSONIQ SQ-R

Musician's Manual
Section 6 - Standard Sound Programming
Noise Rate
r
One of the SQ-R's 15 available modulation sources is NOISE. The Noise
modulator is a signal whose level varies by random amounts. Typically, it might
look like this:
► 100
•100
Noise Source Rate
The Noise Rate defines how frequently the level will change. Low values will
cause it to change very slowly; with high values the level will change quickly.
Range: 00 to 99
Level/Dlay/Mod
LFO Bank
Level
Dlay
Mod
Dlay=80
Mocl=WHEEL
LFO Level — Sets the "manual" level (or depth) of the LFO. Level controls the
initial amount of LFO. The effect of any LFO modulator will be added to this
amount.
Range: 00 to 99
LFO Delay — Determines the time it takes for the LFO to go from zero to the
level set with the "Level" parameter. This is useful for creating delayed vibrato,
tremolo, etc. Higher values give longer delay times.
Range: 00 to 99
LFO Rate Modulation Source — Selects a modulation source for "LFO Speed"
from among the 15 available modulators.
LFO Bank
6 - 23