ENSONIQ SQ-R User Manual

F
SQ-R Musician's Manual Section 4 - Effects
^Selecting Effects . !
r The first parameter of the Effects bank is the effects selector. Changing this j
parameter causes a new effect to be selected, which in turn changes the type of i
parameters that will be available on the rest of the screens. Selecting a new effect {
will automatically set all the effect parameters to their default values for the new
effect. The available Effects are: . »
CONCERT REVERB Concert hall reverb, high density reverberation :
HALL REVERB Hall, left to right (transverse) reflections
ROOM REVERB Small room emulation
WARM CHAMBER Chamber reverb with characteristic resonance
8-VOICE CHORUS Eight voice chorus with complex modulation
CHORUS & REVERB Four-voice chorus combined with reverb
FLANGER+REVERB. 1 Flanger combined with reverb
FLANGER+REVERB.2 (variation with compound modulation)
PHASE SHIFTER Stereo phase shifter with controllable rate and depth
PHASER+REVERB Phase shifter combined with reverb
ROTORY SPKR+VERB Rotating speaker simulator with reverb
DIST+CHORUS+VERB Chorus with distortion plus reverb
CMPRSS+DIST+VERB Compression, Distortion, and Reverb. Great for
guitar and amp simulation with acoustic feedback. •:
Sounds and Presets *
The complete effects setup, including the values of all effect parameters, is saved -:
when you save a sound. It is also saved with each preset. The SQ-R tries to be n
smart about switching effects, since all sound must stop for an instant when it
changes effects. ;,-
When are new effects loaded into the ESP chip? ~
• When you select a sound from Sound Select mode, the effect saved in that
sound will be loaded into the ESP, and you will hear the sound with its effect. '
• When you select a preset, the effect saved in that preset will be loaded into the I '
ESP.
• When you select or layer sounds/tracks from a preset, the effect is not .-*
changed. ?
• When you change the sound on a track the effect will not be changed. ^
Whenever a new effect is loaded into the ESP, the audio output will pause briefly,
allowing the instructions that create the new effect to be loaded into the ESP. If
an effect differs only by variation in parameter values, then this pause may not it
occur. 1|M
:fH:
Vi
Selecting Effects 4-5

ENSONIQ SQ-R Specifications

General

Brand	ENSONIQ
Model	SQ-R
Category	Synthesizer
Language	English