ENSONIQ SQ-R User Manual

Section 8 - Storage Functions SQ-R Musician's Manual
• Once you have selected the operation you want from the four options above,
press Enter/Save.
• If the card was blank or unformatted and you chose COPY INT TO CARD A,
the display asks "Card is wrong type, erase?" Press Yes.
• The copy function is almost instantaneous. The display will read "Command
Successful" after the sounds have been copied.
Sound Storage Prompts and Error Messages
• "Sorry! Install a RAM Card First." — You will get this message if you attempt
to copy INT TO CARD A or INT TO CARD B when there is no card installed,
or when a ROM (Read Only Memory) card is installed.
• "Sorry! Install a Card First." — You will get this message if you attempt to
copy CARD A TO INT or CARD B TO INT when there is no card installed.
• "Sorry! Write to Card A first" — You will get this message if you attempt to
copy INT TO CARD B before you have copied sounds to CARD A. CARD A
must be written before you can copy sounds to CARD B.
• "Sorry! Card B is empty." You will get this message if you attempt to copy
CARD B TO INT when the card is formatted but does not contain sound data in
Card B.
• "Erase preset data on card?" If you attempt to copy INT TO CARD B with a
card which already has preset data stored in the area normally occupied by Card
B sounds, you will get this message. Press Yes to proceed, or No to cancel
the command.
• "Sorry, write to card failed" — This message will appear whenever the SQ-R
fails to verify data that it has written to the card It could mean that the card is a
ROM card and cannot be wntten. It might also mean that the card is write-
protected or possibly defective.
• "WARNING! Battery low. See manual." — If this message appears when a
RAM card is inserted into the card slot, it means that the battery in the card is
getting low and should be replaced as soon as possible. To replace the battery,
you can use essentially the same procedure outlined earlier in this section under
"Installing the Battery in a RAM Card" Also, if you replace the battery while
the card is plugged into the SQ-R, with the SQ-R power on, you will not lose
the data stored on the card. This will not harm the card or the SQ-R. (Make
sure, though, that you do not turn off the SQ-R's power while the card is
installed with the battery removed, or any data on the card will be lost.)
8 - 4 Memory Card Storage

ENSONIQ SQ-R Specifications

General

Brand	ENSONIQ
Model	SQ-R
Category	Synthesizer
Language	English