ENSONIQ SQ-R - Page 86

SQ-R Musician's Manual
Section 6 - Standard Sound Programming
EditVoice
Voice Status
Important:
This parameter determines whether you will be editing one or all voices within a
sound.
• VOICE 1, VOICE 2, VOICE 3 — For each of these values, a single voice
will be selected for editing. The voice named is the voice which will be
affected by any edits to any programming parameters.
• ALL — All voices within the sound which are set to ON are selected and can
be edited as a group. When "ALL" is selected, the SQ-R goes into Group
Edit Mode and changes made to any of the programming parameters will
affect all voices playing within that sound.
The three values on the bottom of the Oscillator Screen are known collectively as
the Voice Status parameter. These values correspond to the three voices that
make up an SQ-R sound. This parameter is used to determine the voice's
playback status.
There are three status options that a voice can be set to on this screen;
• OFF — The selected voice is muted and will not play.
• ON — The selected voice will play.
• SOLO — The selected voice will play and all other voices will be muted.
This is convenient for occasions when you'd like to hear how your edits are
affecting a particular voice.
Once you have selected the particular voice you would like to edit (by selecting
either VOICE1, VOICE2, or V0ICE3 from the EditVoice parameter), only the
voice chosen for editing can be selected on the lower line of the display. Pressing
the Right Arrow button from the Voice Status parameter will cause the SQ-R
to advance to the next parameter screen. When ALL is selected from the
EditVoice parameter, none of the Voice Status parameters can be selected.
Wave Class/Individual Wave
Wave Bank
|Wave Class!
Uave=STRING WflUE
STRING ENSEMBLE
I Individual Wave |
Wave Bank
6 - 9