ENSONIQ SQ-R

, SQ-RMusicians Manual
Section 6 - Standard Sound Programming
Mod Source
Mod Amount
Loop Length
Note:
Modulation Source - Here you can choose which of the 15 modulators will
control the movement of the sound. Any of the modulators can be selected.
Modulation Amount - Determines how much the selected modulator (above) will
affect the wave; i.e. how far away from the start point the sound will move. If
the mod amount is set to +00, the sound will remain static. Positive amounts will
modulate the sound forward (toward the end of the wave); negative modulation
amounts will move the sound back toward the beginning. Both Mod Source and
Mod Amount are applicable to all wave classes except INHARMONIC,
WAVEFORM and MULTI-WAVE.
Range: -99 to+99
»
Controls how many waves will be included in the loop. This parameter is found
only when using MULTI-WAVE.
Range: 000 to 121
Two wave classes, INHARMONIC and WAVEFORM, have no parameters on
this screen. When programming a voice that uses a wave contained within these
wave classes, choosing this screen will have no effect and the following screen
will be displayed. . •
Voice Restrike Decay Time
Wave Bank
Voice Restrike Decay Time
This parameter sets the amount of decay a note will have after it has been
restruck. The higher the value, the longer the decay time.
Range: 00 to 99
Change Sound Mode
Wave Bank
■ I
Change Sound Mode
Press the EnterlSave button to switch the current sound mode. When
working in Standard Sound mode, this command will place the default Drum
Sound into the edit buffer and place the SQ-R in Drum Sound mode.
Wave Bank
6 - 13