HOOK UP - Swave E / E2 / W
ENSOTECH LIMITED
www.ensotech.ltd
INTRODUCTION
Thank you for choosing Swave ESC, its novel technology provides smoothest and ultra-efficient performance.
Please, read this manual, terms and conditions carefully before installing your new Swave electronic speed controller.
If you are looking for certified motor list, warranty terms and conditions, how to dialogistic esc, all of these answer can
be found in Ensotech Shop under the download sector https://shop.ensotech.ltd
If you are looking for supporting motor kv, chassis and characteristic, these can be found in each product descriptions
in https://shop.ensotech.ltd
Here to introduce how to hook up the swave esc, perform calibration and use the SWAVE apps
-Plug-in and solder connections may loose due to vibrations or collisions. Please, ensure secure connections,
otherwise you may experience a short-circuit which will damage the device.
HOOKUP INSTRUCTION
Connect “sensor cable” – a cable between ESC and Ensotech certified sensored motors.
Connect “receiver cable” – a cable between ESC and receiver. We have included two different types of cable plug
(JR & JST) for different type of receivers.
The motor should be well and properly soldered to the ESC for getting full performance from the system and reduce
heating.
A B C
+ -
Hall
Th rottle
Android
Uar t
Lin k
Swave E/ E2/W
Connection
Diagram
Battery
B
A
C
Receiver
Smartphone
MTR
To Next Page
Need help?
General