ENSTROM 280FX OPERATOR’S MANUAL 10-2-1
FAA Approved: Mar 26/12 Rev. 6
Report No. 28-AC-020 Feb 21/12
SECTION 10
SUPPLEMENT 2
FLOAT LANDING GEAR
TABLE OF CONTENTS
SECTION DESCRIPTION PAGE
Table of Contents .................. 10-2-1
Section I General ................................. 10-2-3
Paragraph 10-2-1 Introduction .......................... 10-2-3
10-2-2 Description ........................... 10-2-3
Section II Operating Limitations ............ 10-2-4
Paragraph 10-2-3 Type of Operation .................. 10-2-4
10-2-4 Airspeed Limitations .............. 10-2-4
10-2-5 Altitude Limitations ............... 10-2-4
10-2-6 Center of Gravity Limitations . 10-2-4
10-2-7 Placards ................................ 10-2-5
Section III Emergency Procedures .......... 10-2-9
Paragraph 10-2-8 Engine Failure During Flight
(Above 80 MPH) ..................... 10-2-9
10-2-9 Engine Failure During Flight
(Below 80 MPH) ..................... 10-2-9
Section IV Normal Procedures .............. 10-2-11
Paragraph 10-2-10 Rotor Engagement
(On Water) ........................... 10-2-11
10-2-11 Flight Information ............... 10-2-11
10-2-12 Running Landing ................ 10-2-11
10-2-13 Base Altitude Change .......... 10-2-11
Section V Performance ........................ 10-2-13
Paragraph 10-2-14 General ............................... 10-2-13
10-2-15 Rate of Climb ...................... 10-2-13
Section VI Weight and Balance ............ 10-2-16
Paragraph 10-2-16 General ............................... 10-2-16
10-2-17 Center of Gravity Limits ...... 10-2-16
This electronic document is not linked to a subscription for revision control or distribution. Refer to theTechnical
Publications Status link under the Technical Support Page of the Enstrom Helicopter website for the current revision
level of the 280FX Rotorcraft Flight Manual.
UNCONTROLLED COPY WHEN DOWNLOADED OR PRINTED
To Next Page
Loading...
