ENSTROM 280FX OPERATOR’S MANUAL 10-2-3
FAA Approved: Mar 26/12 Rev. 6
Report No. 28-AC-020 Feb 21/12
SUPPLEMENT 2
FLOAT LANDING GEAR
SECTION I. GENERAL
10-2-1. Introduction
This supplement must be attached to the Approved
Rotorcraft Flight Manual when the Enstrom Float Landing
Gear Kit No. 28-17326-4 is installed. Operation in
compliance with Section 2, “Operating Limitations”, of the
basic manual is mandatory except as modified by this
supplement. Other approved sections and supplemental data
are recommended procedures.
10-2-2. Description
The 28-17326-4 Float Landing Gear Kit consists of two multi-
cell (five compartment) Air Cruisers No. D 24780 inflatable
floats, attachment fittings, relocated pitot tube, and
lengthened landing gear universal blocks.
This electronic document is not linked to a subscription for revision control or distribution. Refer to theTechnical
Publications Status link under the Technical Support Page of the Enstrom Helicopter website for the current revision
level of the 280FX Rotorcraft Flight Manual.
UNCONTROLLED COPY WHEN DOWNLOADED OR PRINTED
To Next Page
Loading...
