ENSTROM 280FX OPERATOR’S MANUAL 4-23
FAA Approved: Mar 26/12 Rev. 6
Report No. 28-AC-020 Feb 21/12
4-20. After Landing
1. Collective down and locked.
2. Landing lights OFF.
3. Radio(s) OFF.
4. Reduce throttle to 2000 RPM for one minute.
5. Throttle to idle (1500 RPM).
6. Clutch disengaged.
CAUTION
Clutch disengagement with throttle open will
result in engine overspeed. Clutch disengage-
ment is signaled by a red warning light on the
instrument console.
7. Idle engine at 1500 RPM for 2 minutes or until cylinder
head temperature cools to 300°F.
8. Boost pump OFF.
9. Mixture control to idle cutoff position.
10. Ignition switch OFF.
11. Master and all other switches OFF.
This electronic document is not linked to a subscription for revision control or distribution. Refer to theTechnical
Publications Status link under the Technical Support Page of the Enstrom Helicopter website for the current revision
level of the 280FX Rotorcraft Flight Manual.
UNCONTROLLED COPY WHEN DOWNLOADED OR PRINTED
To Next Page
Loading...
