ENSTROM 280FX OPERATOR’S MANUAL 4-9
FAA Approved: Mar 12/19 Rev. 12
Report No. 28-AC-020 Dec 3/18
e. Tail rotor hub – check security. Check condition of
teeter stop bumpers.
f. Tail rotor blades – check security. Check for cracks
or bond separations. Check strike tabs for evidence
of strike.
21. Left horizontal stabilizer – check condition and
security.
22. Left vertical stabilizer – check condition and security.
23. Left position and anti-collision lights – check security.
24. Left tail cone – check condition.
25. Driveshaft cover – check security and condition.
26. Left static port – unobstructed.
27. Inspection door
a. Belt drive system – engage manual clutch and check
belt tensioning system for proper rigging. Disengage
manual clutch.
b. Cooling fan – check condition.
28. Left fuel tank
a. Check for leaks, check fuel quantity and cap
secured.
NOTE
When checking the fuel quantity, Enstrom
recommends using a calibrated dipstick.
CAUTION
If the fuel level indication on the dipstick is
lower than 1/4, take-off is not recommended.
29. Upper inspection door
a. Check engine oil quantity – 10 quarts full, 8 quarts
minimum for flight.
This electronic document is not linked to a subscription for revision control or distribution. Refer to theTechnical
Publications Status link under the Technical Support Page of the Enstrom Helicopter website for the current revision
level of the 280FX Rotorcraft Flight Manual.
UNCONTROLLED COPY WHEN DOWNLOADED OR PRINTED
To Next Page
Loading...
