Why is my Entel HT542 Transceiver transmitting without pressing the PTT button?
If your Entel Transceiver transmits without pressing the PTT button, it's likely that VOX has been enabled. To disable it, hold the MEM button for 2 seconds, then use the UP or DOWN button to select “off”.
How to fix Entel HT542 Transceiver not switching on?
If your Entel Transceiver is not switching on, the battery may need charging or be completely exhausted. Try charging the battery pack or replacing it with a fully charged one.
What to do if Entel HT542 Transceiver won't transmit or select high power?
If your Entel Transceiver won't transmit or you cannot select high power, it could be due to a couple of reasons. Some channels might be low power only, or the battery pack might be exhausted. Try switching to a high power channel or charge/replace the battery.
Why does scan key not start scan on Entel HT542 Transceiver?
If the scan key on your Entel Transceiver does not start the scan, it could be due to a couple of reasons. Either no channels are memorized (MEM), or the squelch is not adjusted properly. Use the MEM key to enter the desired channels into the scan memory. Also, adjust the squelch to the threshold or to the point where the white noise just disappears.
How to unlock Entel HT542 Transceiver functions?
If you cannot change any function on your Entel Transceiver, the key lock might be switched on. Turn the key lock off to regain control.
What to do if LED on Entel HT542 Transceiver charger does not illuminate when charging?
If the LED on the charger does not illuminate when charging your Entel Transceiver, it could be due to a defective battery or charger, or dirty terminal contacts on either the battery or charger. Clean the contacts with a dry, clean cloth or contact your dealer.
General| Frequency Range | 136-174 MHz |
|---|---|
| Channels | 16 |
| Power Output | 5W |
| IP Rating | IP54 |
| Battery Type | Li-Ion |
| Battery | 2000 mAh |
To Next Page
