Need help?Do you have a question about the Enterasys 08H20G4-24 and is the answer not in the manual?
General| Model | 08H20G4-24 |
|---|---|
| Ports | 24 |
| Port Type | 10/100/1000Base-T |
| Uplink Ports | 4 |
| Power Supply | Internal |
| Switching Capacity | 48 Gbps |
| Forwarding Rate | 35.7 Mpps |
| Jumbo Frame Support | Yes |
| Jumbo Frame Size | 9216 bytes |
| Redundant Power Supply (RPS) Support | Yes |
| Type | Switch |
| Layer | Layer 2 |
| Form Factor | Rackmount |
| MAC Address Table Size | 16, 000 entries |
Safety guidelines and compliance for Class 1 laser transceivers used in the modules.
Important points to note before beginning the switch installation procedure.
Instructions for placing the switch on a level surface, including rubber feet.
Procedures for installing larger port count switches into racks.
Options for installing smaller 8-port switches in various configurations.
Steps for connecting the switch to the AC power source.
Guides for connecting optional external redundant power supplies.
How to connect to the console port for local management and CLI access.
Steps to connect to the switch using the Web User Interface.
Procedures for connecting network cables (UTP, SFP) to the switch ports.
Final steps including cable management and initial login to switch management.
Defines the behavior and meaning of various LEDs on the switch.
Provides a list of common problems, causes, and recommended solutions.
To Next Page