Need help?Do you have a question about the Enterasys SSA-G1018-0652 and is the answer not in the manual?
General| Model | SSA-G1018-0652 |
|---|---|
| Type | Managed Switch |
| Speed | 10/100/1000 Mbps |
| Power Supply | Internal |
| Switching Capacity | 36 Gbps |
| Forwarding Rate | 26.8 Mpps |
| MAC Address Table Size | 8K |
| VLANs | 256 |
| Jumbo Frame Support | Yes |
| Ports | 16 10/100/1000BASE-T ports, 2 SFP ports |
| Layer | Layer 2 |
Describes the available AC power supply models and their features, including redundancy modes.
Explains Power over Ethernet support and its capacity on the SSA models.
Lists the essential tools needed for installing the SSA hardware.
Covers general guidelines for mounting the SSA in various rack types or on a desktop.
Step-by-step guide for mounting the SSA in a four-post equipment rack.
Instructions for mounting the SSA in two-post racks with 7-inch posts.
Instructions for mounting the SSA in two-post racks with 3-inch posts.
Guide for physically installing the power supply units into the SSA chassis.
Steps to connect the SSA to power sources and initial power-on sequence.
Procedures for connecting the SSA to the network via Ethernet cables and transceivers.
Details on connecting Category 5 UTP Ethernet cables to RJ45 ports.
Instructions for installing SFP and SFP+ pluggable transceivers into SSA ports.
How to connect a PC or terminal to the SSA's COM port for local management.
A guide to common problems, their causes, and recommended solutions.
Instructions for replacing the SSA's internal cooling fans.
To Next Page