Enterasys SSA-G1018-0652 - Installation; Required Tools for Installation

Enterasys S-Series Stand Alone (SSA) Hardware Installation Guide 2-1
2
Installation
Followtheorderofthesectionslistedbelowforcorrectinstallation:
Required Tools
•ESDwriststrap(includedwiththeSSA)
• Phillipsscrewdriver
Electrical Hazard: Only qualified personnel should perform installation procedures.
Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de instalacion.
Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und qualifiziertes
Personal vorgenommen werden.
For information about... Refer to page...
Required Tools 2-1
Unpacking the SSA 2-2
Mounting the SSA 2-3
Unpacking the Power Supplies 2-12
Installing the Power Supplies 2-13
Powering Up the SSA 2-14
Connecting to the Network 2-16
Connecting to the COM Port for Local Management 2-18
Completing the Installation 2-20
Important Notice
Read the Release Notes specific to the firmware image running in the chassis to check for any
exceptions to the supported features and operation documented in this guide.