Enterasys SSA-G1018-0652 - Attaching the Rails to a Four-Post Rack

Mounting the SSA
Enterasys S-Series Stand Alone (SSA) Hardware Installation Guide 2-5
3. Attacheachrailtotherackpostswithtwoscrewsinthefrontandtwoscrewsinthebackin
thetopandbottomscrewholes.SeeFigure 2‐1.
TheSSArailkitdoesnotincludescrewsforattachingtherailstotherackposts.
Figure 2-1 Attaching the Rails to a Four-post Rack
4. Ifnecessary,tightenthe screws
thatsecuretherailextensionstotherails.
ThesescrewsmustbetightbeforeyouplacetheSSAintherails.
5. Fromthefrontoftherack,slidetheSSAontothe railsuntilthemountingearsoftheSSAare
againstthefrontpostsoftherack.