Enterasys SSA-G1018-0652 - Setting the Mode Switches

Setting the Mode Switches
B-4 Resetting Mode Switches
Setting the Mode Switches
Beforesettingthemodeswitches,youmustpowerdowntheSSA.
1. PutontheESDwriststrapandattachittothegroundreceptacleonthefrontoftheSSA.
2. RemovetherearpaneloftheSS Abyunscrewingthefourzinc(silver)screwsfromtherear
panel.SeeFigure B‐2.
Figure B-2 Removing the Rear Panel
3. Resettheappropriateswitch.
4. ReplacetherearpaneloftheSSA.