9033644 Installation 27
Table 2-6 specifies the fiber types, bandwidth requirements, and length
constraints for the Gigabit Ethernet long-wavelength fiber interface on the
fiber optic media module.
Table 2-6. 1000Base-LX Fiber Specifications
10Base-T/100Base-TX Ports
The 10Base-T/100Base-TX ports use RJ-45 connectors. Figure 2-6
shows an RJ-45 connector being inserted into a port.
Figure 2-6. Inserting an RJ-45 Connector into a Port
The ports on the base unit are wired with the MDI-X function
implemented. These ports interface to UTP cabling for
connection to
10Base-T or 100Base-TX network segments or end-stations.
These UTP
connections meet the requirements of ISO 8877, specified by 10Base-T,
Section 14 of the IEEE 802.3 specification. Workstations or servers can
be connected to these ports using standard straight-through wired cables.
For connections to other switches or hubs, use an MDI port on the other
device. If an MDI port is not available, a crossover
cable may be
necessary (refer to “
MDI/MDI-X Crossover Cable Wiring” in Appendix A).
See Table A-2, “10Base-T/100Base-TX Pinouts,” for 10Base-T/
100Base-TX connector pin assignments.
Fiber Diameter
(microns)
Modal Bandwidth @ 1300 nm Range
62.5 µm MMF 500 MHz/km 2-550 Meters
50 µm MMF 500 MHz/km 2-550 Meters
50 µm MMF 400 MHz/km 2-550 Meters
10 µm SMF N/A 2-5000 Meters
To Next Page
Loading...
