Entrematic EM PSW250 - User Manual

90 pages

Save Page as PDF

To Next Page

Swing Door Operator

EM PSW250

Installation and Service Manual

Original instructions

1007913-EMen-17.0 – Issue 2018-08-07

Main Page

Table of Contents3
Revision6
Instructions for Safe Operation7
Important Information8
Intended Use8
Safety Precautions8
Electronic Equipment Reception Interference8
Environmental Requirements9
Technical Specifications10
Permitted Door Weight and Door Width for EM PSW25011
How the EM PSW250 Works12
Opening13
Closing13
Control Switch13
OFF/AUTO/OPEN Switch13
Functions on the Basic Control Unit CUS714
Power Failure14
Closing Torque14
Extended Closing Torque (CLTQ)14
Power Assist (POAS)14
Push and Go (PAG)14
Inverse (INV)14
Activation Delay (AD)14
Overhead Presence Detector (OPD), Frame Mounted14
Mat15
Double Acting15
Functions on the Extension Unit EXU-SI16
KILL or FIRE Function16
Function of Locks16
Program Selector (Wall Mounted)16
Impulses16
OPEN/CLOSE Impulse16
Power Failure Mode (Backup Batteries Are Installed) Optional16
Nurse and Bed Functionality18
Functions on the Extension Unit EXU-SA19
Presence Impulse Approach, Door Mounted19
Presence Detection Swingpath, Door Mounted19
Monitored Safety Sensors19
FIRE Input19
Relay Output19
Models21
Single Operator, Surface Mounted21
Double Operator, Surface Mounted22
Part Identification23
Arm Systems25
Pushing Installation with PUSH-Arm25
Pulling Installation with PULL-Arm26
MM Extension26
Pushing Installation with PULL-Arm27
Drive Shaft Extension Kits28
Options29
Control Switches29
4-Position Switch PS-4C (Operates the Electric Lock)29
Sync Cable for Double Doors (Synchronizing of 2 Operators)29
Coordination Unit29
LED Cable30
Battery Backup Unit30
Cover Piece Kit30
Closing Time Board Kit30
Fire Kit31
Mounting Plate (for Reinforcement of Wall)31
Labels32
Pre-Installation33
General Tips/Safety Concerns33
Operator/Door Handing33
Installation Examples34
Fastening Requirements (but Not Included)34
Tools Required35
Mechanical Installation36
PUSH Arm System39
PULL Arm System45
Operator with Sliding PUSH Arm System51
Inverse Installation with PUSH Arm System52
Inverse Installation with PULL Arm System53
Installation of Coordination Unit on Fire Door Installations54
Motor Unit55
Electrical Connection60
Mains Connection60
Control Units61
Cus761
Arm System Selection61
Extension Units EXU-SI / EXU-SA62
Installation62
Extension Unit EXU-SI63
Extension Unit EXU-SA64
Installation on Double Doors65
How to Cut the Jumper on the Sync Cable for Double Doors65
Double Door Installations66
Settings for Double Doors66
Sensor Cable Inlet67
Reset and Indication Device for Fire Doors68
Start-Up70
Spring Pre-Tension70
Micro Switch71
Adjusting the Door Stop71
Auto-Learn-Automatically Sets Back and Latch Check (Recommended)73
Push the LEARN BUTTON (LRN)74
Double Doors74
General Adjustment74
Connection of Activation Units and Accessories75
Cover76
Fitting and Removing the Cover76
Cover Piece Kit76
Signage77
Advanced Settings78
Learn with Advanced Setting of "Back- and Latch-Check78
Revert to Default Values for "Back- and Latch-Check" (Level 1)78
Changing Group of Parameters (Level 2)79
Classification (Level 3)82
Overhead Presence Detection and Interlock (Level 4)83
Enhanced Lock Kick, Fire Input and Extended Arm Selection (Level 5)84
Guide for Installation and Adjustments85
Complementary Safety Devices Swing Doors85
Swing Doors Opening and Closing Time85
How to Find the Correct Opening and Closing Time85
Diagrams for Door Weight86
Aluminium Frame with Glass86
Troubleshooting87
Error Indication88
Service & Maintenance89

Brand	Entrematic
Model	EM PSW250
Category	Door Opening System
Language	English

Entrematic EM PSW250 - User Manual

Table of Contents

Entrematic EM PSW250 Specifications

Related product manuals