Enttec DMX USB PRO - Appendix 2 - FCC Declaration; Federal Communications Commission (FCC) Declaration of Conformity

Appendix 2 - FCC Declaration
Federal Communications Commission (FCC)
Declaration of Conformity
Responsible Party: ENTTEC Pty Ltd
PO Box 282,
Kew, Vic, 3101
Australia
declares that the products DMX USB PRO complies with Part 15
of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the
receiver.
- Connect the equipment into an outlet on a circuit
21