Drawings are subject to change without notice. Refer to www.enviro-tec.com for current submittal drawings.
(TYPICAL EACH SIDE)
PARTIAL REAR VIEW
FRONT VIEW
TOP VIEW
SIDE VIEW
DIMENSIONS - In [mm]
ordinances.
Provide sufficient clearance to access electrical
controls and comply with applicable codes and
field to match individual job requirements.
8. Field piping casing penetrations must be cut in the
7. Internal insulation of field piping may be required.
optional electrical enclosure, coil, and drain pan.
6. Fixed bottom panel is removable for access to
access to filter and fan assembly.
5. Louvered bottom panel is hinged and removable for
indicated to provide proper drain slope.
4. Drain piping should be routed through casing opening
optional features.
3. Electrical enclosure size and location may vary with
2. Left hand unit shown, right hand unit opposite.
conversion.
dimensions ±1/4" [6mm]. Metric values are soft
1. All dimensions are Inches [millimeters]. All
NOTES:
DRAIN TUBE EXIT
1-1/8 K.O. FOR
ELECTRICAL ENTRY
TWO 7/8 K.O. FOR
RESILIENT GROMMET
ROD HOLES WITH
3/8 [10] DIA HANGER
3-1/2 [89]
1-5/8 [41]
[76]
3
[94]
3-11/16
[137]
5-3/8
RETURN GRILLE
STAMPED STEEL
SUPPLY GRILLE
STAMPED STEEL
[838]
33
[57]
2-1/4
[210]
8-1/4
[32]
1-1/4
[305]
12
[165]
6-1/2
F
E
[38]
1-1/2
[762]
30
[38]
1-1/2
D
C B
A
5-1/435-1/2
43
6-1/4
46
23-1/2
25
6-1/4
6-1/4
5-1/4
67-1/2
27-1/2
39-1/2
47-1/2
59-1/2
6-1/4
5-1/4
F
6-1/4
6-1/4
7-1/4
80
70
B C ED
47
57
7-1/4
77
67
37
6-1/4
A
UNIT
SIZE
27-1/2
39-1/2
40
47-1/2
59-1/2
50
60
20
30
40
50
60
19-1/2
[133][902][1092][159][597][1168]
[159]
[159]
[133]
[1715]
[699]
[1207]
[1511]
[1003] [133]
[159]
[159]
[159]
[184][1778]
[2032]
[940]
[1448]
[1194]
[159]
[184]
[1702]
[1956]
[1016]
[1270]
[1524]
[1511]
[495]
[1003]
[1207]
[699]
To Next Page
Loading...
Need help?
General
