Enviro PRO-NS-0844 - User Manual

Questions and Answers

W
William RodriguezAug 8, 2025
What to do if water pressure is slowing immediately after Enviro PRO-NS-0844 Water Dispenser installation?
- R
  Roberta JohnsonAug 8, 2025
  Avoid high flow rates from bathtubs, utility sinks, hose bibs, multi-headed showers, body sprayers, or anything considered high flow for the first 72 hours after installation. If you suspect a carbon blockage of the top basket due to a high-flow situation within the first 72 hours, turn off any running water for at least 10 minutes to clear the blockage, then resume using water at low or normal flow rates.
M
Maria ParkerAug 14, 2025
What to do if Enviro PRO-NS-0844 water pressure is slowing?
- D
  Diane FloresAug 14, 2025
  It is recommended to replace the Sediment Filter every 6-9 months, depending on the amount of sediment in your water supply. If your system has been working properly and the pressure is slowing, check the Sediment Filter and replace it if necessary.
M
margaret51Aug 20, 2025
Why is the pressure dropping off during the carbon wash of my Enviro PRO-NS-0844?
- B
  Brett HughesAug 20, 2025
  The pressure may drop off during the carbon wash because there is air trapped in the carbon bed. To resolve this, turn the water off and let the tank sit for about 30 minutes to allow the carbon to settle. If the pressure drops again, let the system stand for 72 hours. After 72 hours, continue the carbon wash by slowly turning the water supply back on.
R
Roger SotoAug 27, 2025
What to do if water is leaking at the top of the Enviro Water Dispenser tank?
- O
  Omar StewartAug 27, 2025
  You may need to tighten the head of the tank. Turn the head to tighten it, ensuring it is snug but not overtightened. The tank head is pre-installed hand-tight, so avoid overtightening.
B
barbara99Aug 31, 2025
Why does Enviro Water Dispenser water appear grey or cloudy?
- M
  michellewattsSep 1, 2025
  Water may appear grey or cloudy for the first seven to ten days after installation due to extra carbon dust.