Envirovent energiSava 250 Installation Guide

16 energiSava
®
250
01423 859 395
SHOULD YOU ENCOUNTER ANY PROBLEMS
INSTALLING THIS UNIT, CALL US ON:
To manually activate or deactivate the summer bypass function
(in manual bypass mode):
• Press any button to wake the remote control.
• Press the button again twice. The bypass LED will flash (red).
After 2 seconds the unit will enter bypass mode for 24 hours then
automatically return to the normal running mode.
• To deactivate the summer bypass mode, repeat the above steps.
Filter indicator and reset:
• If on waking the remote control the filter LED flashes (green), the
filters need to be replaced. Contact EnviroVent to order new filters.
• After replacement filters have been installed, wake the remote
control.
• Press and hold the button for 5 seconds, the filter LED will flash green.
• Press and hold the button for 5 seconds again to reset the filter, the
filter LED will flash rapidly for 2 seconds to confirm the filter reset.
Pairing an extra remote control:
• Turn the unit off at the isolation point.
• Restore the power to the unit. For 20 seconds from restarting, the
unit will be in pairing mode.
• Press the button on the new remote control once within the 20
seconds and the remote control will pair to the unit.
• If LED 2 lights green, the pairing has succeeded.

Envirovent energiSava 250 Specifications

General

Brand	Envirovent
Model	energiSava 250
Category	Heating System
Language	English