Need help?Do you have a question about the Envirovent VENTY ECO2 Air and is the answer not in the manual?
Ensure diffusers are not positioned within 1m of a smoke detector.
All wiring must comply with Building Regulations and current I.E.E. Wiring Regulations.
Prepare the site, protect lungs, mark and cut the diffuser hole in plasterboard.
Locate, orient, fix, and seal the inline filter correctly in the ducting.
Connect unit to electrical supply by a competent person using disconnection device.
Adjust ventilation rate using the house setting button on the unit.
Press button for five seconds to toggle heater on/off; LED indicates status (red).
Ensure diffusers are not positioned within 1m of a smoke detector.
All wiring must comply with Building Regulations and current I.E.E. Wiring Regulations.
Prepare the site, protect lungs, mark and cut the diffuser hole in plasterboard.
Locate, orient, fix, and seal the inline filter correctly in the ducting.
Connect unit to electrical supply by a competent person using disconnection device.
Adjust ventilation rate using the house setting button on the unit.
Press button for five seconds to toggle heater on/off; LED indicates status (red).
General| Brand | Envirovent |
|---|---|
| Model | VENTY ECO2 Air |
| Category | Fan |
| Language | English |
To Next Page