5/ XPS3 EOTECHINC.COM /
SHOW SOME RESPECT / 1
Caution
Never disassemble the sight’s optical assembly. The optical cavity is purged,
nitrogen filled, and sealed to achieve fog-resistant performance. Disassembly
will void the warranty and render the sight inoperable.
Ensure the HWS is off before using night vision mode. Once the sight is OFF,
pressing the NV button activates the NV mode for use with an HWS in tandem
with a night vision device. Brightness settings in NV mode are only detectable
when using night vision.
When a sudden increase in resistance is felt in the elevation or windage
adjustment shafts, the end of the adjustment range has been reached.
DO NOT TURN THE ADJUSTMENTS ANY FARTHER OR SERIOUS DAMAGE
MAY OCCUR TO THE SIGHT.
Always dampen the glass surfaces prior to cleaning. Never clean the glass
surface with a dry cloth or paper towel.
All moving parts of the sight are permanently lubricated. Do not try to
lubricate them.
Do not use deteriorated or corroded batteries. Inspect batteries for rips, tears,
dents, or cuts in the battery housing. If there is any exposed internal content
of the battery, it could affect the operation of the sight.
The XPS3 HWS units are designed to mount directly to either a 1" (25.4mm)
Weaver or MIL-STD-1913 rail specification.
To Next Page
Loading...
