Advanced Tab
On the Advanced tab, you can change settings that will aect the entire job. More features will be added
to this tab in the near future.
• Copies: Set the number of times you would like to rerun the job. If you have 2 processes, the laser
will complete each of the two processes, then run the two processes a second time. If you have a
process with more than one cycle (process 1: cycles 1, process 2: cycles: 2) and set the copies to 2, it
will run process 1 once, process 2 twice, then process 1 once again, and process 2 twice more. This is
useful when using the fiber laser with the system.
Notes Tab
Use the Notes tab to keep notes on running your file. This can include suggestions for artwork placement,
speed and power notes, or anything else a laser operator may find helpful when running that project.
- 67 -
SECTION 5: THE LASER DASHBOARD
To Next Page
Loading...
