02
IMPORTANT SAFETY INSTRUCTIONS
CAUTION –
Failure to follow the instructions may cause bodily injury or property
damage.
GROUNDING INSTRUCTIONS
This product should be grounded. In the event of an electrical short circuit, grounding reduces
the risk of electric shock by providing an escape wire for the electrical current.
The plug must be plugged into an outlet that is properly installed and grounded.
DANGER – Improper use of the grounding plug can result in a risk of electric shock.
If repair or replacement of the cord or plug is necessary, do not connect the grounding wire to
either flat-head terminal.
Check with a qualified electrician or serviceman if the grounding wire instructions are not
completely understood, or if in doubt as to whether the product is properly grounded.
This product is factory equipped with a specific electric cord and plug to permit connection to
a proper electric circuit. Make sure that the product is connected to an outlet having the same
configuration as the plug. No adapter should be used with this product. Do not modify the plug
provided — if it will not fit the outlet, please have the proper outlet installed by a qualified
electrician. If the product must be reconnected for use on a different type of electric circuit, the
reconnection should be made by qualified service personnel.
SAVE THESE INSTRUCTIONS
1. Do not install or use the product in wet places such as a steam room etc.
2. It is recommended to use water-proof electrical outlet which should be installed in a place
where is not easily to get wet.
3. This product should be used with 110V-120V, 50/60Hz electrical current only, load current
is at least 15A. Power plug must be equipped with ground fault circuit interrupter or ground
fault electrical leakage protector or similar high sensitive, rapid type leakage switch. (Rated
sensitive current under 6mA).
4. When it thunders, it is strongly recommended to pull out the power plug.
5. Do not stand on product unit, seat and lid.
6. Do not lean against the lid when using the product, to avoid damage.
7. This product is equipped with a soft-closing seat and lid. Do not push the toilet seat closed,
or damage may occur.
8. Do not use any caustic chemicals or scrubbing brush to clean this product.
9. Exposure to direct sunlight is prohibited.
10. Only use tap water or potable water; otherwise it may cause chafing.
11. Do not connect water supply to a hot water supply. Make sure inlet water temperature is
between 3~35℃/37.4~95℉.
12. Raise room temperature to prevent the toilet from damage due to freezing.
13. When not using the product over three(3) days, drain the water out of the toilet and pull
the electrical plug from the wall outlet.
14. Stop using the product and shut off the power when product malfunctions. Call for
professional service.
15. Means for full disconnection must be incorporated in series in the power input loop of
the same room where the product is installed, that is at the front end of the fixed wiring
to ensure safe use.
To Next Page
Loading...
