Plug AC adapter through
port hole on wall mount
AC Outlet
3
BATTERY CHARGING
Before first use the detachable lithium-ion battery must be fully charged. It can be charged either installed
or uninstalled by connecting the power cord to the recharging port and a standard electrical outlet.
NOTE: During rst use, run the battery all the way down to properly condition it, then charge fully. It takes
approximately 2.0 hours to charge battery completely. Fully charge and discharge the battery every 3 months when
vacuum is not in use for a long period of time.
If wall-mount is not used, place hand
vacuum on a flat, stable surface.
Connect the power cord directly to
charging port located on the battery.
AFTER INITIAL CHARGING, ALLOW BATTERY PACK UP TO 2.0 HOURS TO FULLY RECHARGE.
Hand Vacuum
Storage Wall Mount
Port
If using the wall-mount bracket (or individual battery
pack wall mount), follow instructions for installation.
Plug in assembled product while stored in wall mount.
Unplug when not in use for extended periods of time.
Port Access
Port Access
Direct Connection Wall Mount Storage Station
*Run Times are estimates and can vary by accessory tool in use,
filter cleanliness, and other factors.
Convenient
Charging & Storage
The wall-mounted storage dock
neatly holds the cord-free vacuum
with interchangeable accessories
and allows mounted plug-in
charging in less than 2.0 hours
installed or removed from the unit.
Removable/Rechargeable
8-Cell 2200mAh Li-Ion Battery Pack
Up to 50 Minutes
Run Time/Charge
Up to 25 Minutes
Run Time/Charge
Up to 15 Minutes
Run Time/Charge
Ideal for floors and carpeting
Whole Room/Office
Ideal for small room, cushions,
drapes, and car interiors
Ideal for quick pick-ups and
bursts of power for small messes
ECO
Mode
NORMAL
Mode
TURBO
Mode
Individual
Battery Pack
Wall Mount
To Next Page
Loading...