Corrective Action:
Please, follow this procedure to remove the card.
1. Check that the printer is off an the AC power cable is unplugged
2. Loosen up completely the thumbscrews on the IEEE 1394 card.
3. Carefully pull the card straight out.
4. If the card gets jammed do the following:
a. Carefully push the card back inside.
b. Slightly raise the card so it touches the top of the slot housing.
c. While keeping the card touching the top, pull it out.
This procedure should allow the card to be pulled out safely, see the figure bellow as an illustration:
Push up
Push up
Pull out
To Next Page
Loading...
