Epson EMP MONITOR OPERATION V4.30 - User Manual

42 pages

To Next Page

EMP Monitor Operation Guide

V4.30

Main Page

Questions and Answers

A
Andrew OconnorAug 11, 2025
Why can't I monitor or control my Epson EMP MONITOR OPERATION V4.30 projector?
- A
  Aaron LawsonAug 11, 2025
  If Epson Software EasyMP Monitor cannot monitor or control the projector, first ensure the network cable is correctly connected; if not, reconnect it. Then, verify the settings in the Network configuration menu. Also, confirm that EasyMP Monitor is correctly installed on your computer by uninstalling and reinstalling it. Ensure all projectors are registered. Finally, the projector's Standby Mode should be set to Communication On (or Network On), or Network Monitoring should be set to On in the configuration menu to enable monitoring and control via EasyMP Monitor in standby mode.
J
Joseph PetersonAug 26, 2025
What to do if Epson EMP MONITOR OPERATION V4.30 doesn't send e-mail messages when a problem occurs?
- D
  Derrick ChavezAug 26, 2025
  If you are not receiving e-mail notifications from Epson Software when a problem occurs, check that the SMTP server IP address, Port Number, and Recipient mail address are correctly configured. Also, ensure the projector's Standby Mode is set to Communication On (or Network On) or Network Monitoring is set to On in the configuration menu. If the projector has momentarily stopped working due to a critical problem, it won't be able to send e-mails; in this case, and if the projector cannot be reset after checking, contact Epson. Finally, verify that the projector is receiving power and that the circuit breaker hasn't tripped.