To Next Page
X
xwernerAug 11, 2025
Why can't I monitor or control my Epson 821p - PowerLite XGA LCD Projector projector?
- CChristopher HarrisAug 11, 2025
If Epson Software EasyMP Monitor cannot monitor or control the projector, first ensure the network cable is correctly connected; if not, reconnect it. Then, verify the settings in the Network configuration menu. Also, confirm that EasyMP Monitor is correctly installed on your computer by uninstalling and reinstalling it. Ensure all projectors are registered. Finally, the projector's Standby Mode should be set to Communication On (or Network On), or Network Monitoring should be set to On in the configuration menu to enable monitoring and control via EasyMP Monitor in standby mode.
General
