Color Difference Correction when Projecting from Multiple Projectors
77
When lining up multiple projectors to project images, you can correct the
brightness and color tone of each projector's image so that the images match
closely.
You can set a unique projector ID for each projector to operate them
individually using a remote control, and then correct the brightness and color
for each projector.
a
• In some cases the brightness and color tone may not match
completely even after correction.
• If brightness and color tone differences become more noticeable over
time, repeat the adjustments.
gg Related Links
• "Setting the Projector ID" p.77
• "Selecting the Projector You want to Operate" p.77
• "Matching Multiple-Projector Display Quality" p.79
Setting the Projector ID
To control multiple projectors from a remote control, give each projector a
unique ID.
a
Press the [Menu] button on the control panel or remote control.
b
Select the Extended menu and press [Enter].
c
Select Projector ID and press [Enter].
d
Use the arrow buttons to select the identification number you want to
use for the projector. Then press [Enter].
e
Press [Menu] or [Esc] to exit the menus.
Repeat these steps for all the other projectors you want to operate from one
remote control.
Selecting the Projector You want to Operate
After setting the projector's ID, select the ID for the projector you want to
operate using the remote control.
To Next Page
Loading...
Need help?
General
