• When you select Level 5, adjust the brightness to match the
darkest image.
• When you select Level 1, adjust the brightness to match the
brightest image.
• When you select Level 2 to Level 4, adjust the brightness to the
mid-range brightness image.
• Because you can switch between a pattern display and the normal
image each time you press the [Enter] button, you can check the
correction results and correct the brightness in the actual image.
e
Adjusting Color Correct. (G/R) and Color Correct. (B/Y).
f
Repeat procedures 3 to 5 until corrections are finished.
g
When all corrections are finished, press the [Menu] button to finish
making settings.
Saving a User's Logo
You can save the image that is currently being projected as a User's Logo.
a
Once a User's Logo has been saved, the logo cannot be returned to the
factory default.
a
Project the image you want to save as the User's Logo, and then
press the [Menu] button.
s "Using the Configuration Menu" p.85
Using the remote control Using the control panel
b
Select User's Logo from Extended.
Projection Functions
68
To Next Page
Loading...
Need help?
General
