Installing the Touch Unit
110
h
Touch ( ) displayed on the screen with your finger and check if ( ) is displayed in the
same position
Touch all four ( ) to confirm.
Screen Status
Adjustment has been performed correctly if the lo-
cation you touch with your finger is the same place
as where (
) is displayed.
If ( ) is displayed in a different location to the
point you touched, select Up once using the control
panel or the remote control. Next, touch (
)
again with your finger to confirm.
Repeat until (
) is displayed in the correct posi-
tion.
Adjustment is complete when ( ) appears in the correct position for all four ( ) positions.
Go to "Calibrating the Touch Operation Position" p.120.
To Next Page
Loading...
