Installing the Wall mount
61
e
Select Screen Type from the Installation menu to set the aspect ratio of the projected
image
f
Change the aspect ratio if necessary
Project images from a connected device, and then press the [Aspect] button on the remote control.
Each time you press the button, you see the aspect name on the screen and the aspect ratio changes.
c
The aspect ratio does not change when no images are being projected from the connected
device.
Auto Screen Adjustment
Attach corner markers (supplied with the projector) to the four corners of the projection position to
automatically adjust the position of the image.
Auto Screen Adjustment works correctly under the following conditions.
•
Projection size: 100 inches or less
•
Projector direction: Within ±1° up, down, left, or right
c
•
Auto Screen Adjustment may not work properly depending on the surface of the projected screen.
The following conditions are necessary to perform Auto Screen Adjustment.
•
A flat projection surface
•
No patterns, dirt, or obstacles on the projection surface
•
Before performing the Auto Screen Adjustment, set the Screen Type setting first. If you change the
Screen Type after performing Auto Screen Adjustment, the adjustments will be reset.
To Next Page
Loading...
