a
• If you set Standby Mode to Communication On, you can perform the following operations even if the projector is in standby mode.
- Outputting images to an external monitor
- Outputting microphone audio from the projector's speaker (only when Standby Microphone is set to On).
s
Extended - Standby Mode p.81
s Extended - Standby Microphone p.81
• Only analog RGB signals from the Computer1 port can be output to an external monitor. You cannot output signals input from other ports or component video
signals.
• Setting gauges for functions such as Keystone, Configuration Menu, or Help screens are not output to the external monitor.
• When the audio cable jack is inserted into the Audio Out port, audio stops being output from the projector's built-in speakers and switches to external
output.
Connecting a LAN Cable (EB-925/EB-915W/EB-905/EB-96W/EB-95 only)
Connect a LAN port on network hubs or other equipment to the projector's LAN port with a commercially available 100BASE-TX or 10BASE-T LAN
cable.
a
To prevent malfunctions, use a category 5 shielded LAN cable.
Connecting Equipment
27
To Next Page
Loading...
Need help?
General
