Image Shape
53
e
Select Arc Correction and press [Enter].
You see the area selection screen.
f
Use the arrow buttons to select the area of the image you want to
adjust, then press [Enter].
a
To reset the Arc Correction settings, hold down [Esc] for about
two seconds while the area selection screen is displayed, and then
select Yes.
g
Press the arrow buttons to adjust the image shape of the selected area as
necessary.
To return to the area selection screen, press [Enter].
a
If you see this screen, you cannot adjust the shape any further in
the direction indicated by the gray triangle.
h
Repeat steps 7 and 8 as needed to adjust any remaining areas.
i
When you are finished, press [Esc].
To Next Page
Loading...
