Submenu Function
Control Panel
Lock
You can use this to restrict operation of the projector's control
panel.
s "Restricting Operation (Control Panel Lock)" p.51
Pointer Shape
You can select the shape of the pointer.
Pointer 1:
Pointer 2:
Pointer 3:
s "Pointer Function (Pointer)" p.43
Power Consump-
tion
You can set the lamp brightness to one of two settings.
Select ECO if the images being projected are too bright, such as
when projecting images in a dark room or onto a small screen.
When ECO is selected, the power consumption and the lamp's
operating life are changed as follows, and fan rotation noise
during projection is reduced.
Electrical consumption: about 17.5% decrease, lamp life: about
1.25 times longer
When the projector is used at a high altitude or in a location
subject to high temperatures, the ECO setting may be used
automatically. If this happens, Power Consumption is grayed
out and cannot be adjusted.
Volume
You can adjust the volume. Setting values are saved for each
source.
For EB-W01/EB-S01, this item cannot be set when the input
source is Computer.
Remote Receiver
You can limit the reception of the operation signal from the
remote control.
When set to Off, you cannot perform any operations from the
remote control. If you want to make operations from the remote
control, hold down the [Menu] button on the remote control for
at least 15 seconds to reset the setting to its default value.
Submenu Function
User Button
You can select and assign an item from the Configuration menu
with the remote control's [User] button. Pressing the [User]
button directly displays the assigned menu item selection/
adjustment screen, allowing you to make one-touch changes to
settings/adjustments. You can assign one of the following items
to the [User] button.
Brightness Control, Info, Progressive, Test Pattern,
Resolution
Test Pattern
When the projector is set up, a test pattern is displayed so that you
can adjust the projection status without connecting equipment.
While the test pattern is displayed, zoom, focus adjustments, and
keystone correction can be performed. To cancel the test pattern,
press the [Esc] button on the remote control or the control panel.
Attention
If a pattern is displayed for a long time, a residual
image may be visible in projected images.
Reset
You can reset all adjustment values on the Settings menu to their
default settings, except for Zoom (EB-S02/EB-S01 only) and
User Button.
See the following to return all menu items to their default
settings.
s "Reset Menu" p.63
List of Functions
60
To Next Page
Loading...
Need help?
General
Weight and Dimensions
