EasyManuals Logo

Epson EB-S02 User Manual

Epson EB-S02
103 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #97 background imageLoading...
Page #97 background image
DECLARATION of CONFORMITY
According to 47CFR, Part 2 and 15
Class B Personal Computers and Peripherals; and/or
CPU Boards and Power Supplies used with Class B Personal Computers
We: Epson America, Inc.
Located at: 3840 Kilroy Airport Way
MS: 3-13
Long Beach, CA 90806
Tel: 562-290-5254
Declare under sole responsibility that the product identified herein,
complies with 47CFR Part 2 and 15 of the FCC rules as a Class B digital
device. Each product marketed, is identical to the representative unit tested
and found to be compliant with the standards. Records maintained continue
to reflect the equipment being produced can be expected to be within the
variation accepted, due to quantity production and testing on a statistical
basis as required by 47CFR 2.909. Operation is subject to the following two
conditions : (1) this device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that
may cause undesired operation.
Trade Name: EPSON
Type of Product: Projector
Model: H428C/H429C/H430C/H431C/H432C/H433C/
H434C/H435C/H436C/H437C/H438C/H439C
FCC Compliance Statement
For United States Users
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio or television
reception. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause interference to radio
and television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures.
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
WARNING
The connection of a non-shielded equipment interface cable to this
equipment will invalidate the FCC Certification or Declaration of this
device and may cause interference levels which exceed the limits established
by the FCC for this equipment. It is the responsibility of the user to obtain
and use a shielded equipment interface cable with this device. If this
equipment has more than one interface connector, do not leave cables
connected to unused interfaces. Changes or modifications not expressly
approved by the manufacturer could void the user's authority to operate the
equipment.
Specifications
97

Table of Contents

Other manuals for Epson EB-S02

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Epson EB-S02 and is the answer not in the manual?

Epson EB-S02 Specifications

General IconGeneral
Matrix size0.55 \
Native aspect ratio4:3
Projection distance- m
Projection technology3LCD
Supported aspect ratios-
Contrast ratio (typical)3000:1
Screen size compatibility30 - 350 \
Projector native resolutionSVGA (800x600)
Keystone correction, vertical± 30 °
Projector brightness (economic mode)2080 ANSI lumens
FocusManual
Offset8:1 %
Throw ratio1.45 - 1.96:1
Digital zoom1.35 x
Focal length range- mm
Lamp typeUHE
Lamp power200 W
Light source typeLamp
Service life of light source4000 h
Service life of light source (economic mode)5000 h
DVI portNo
USB connector typeUSB Type-B
USB 2.0 ports quantityUSB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
S-Video inputs quantity1
Ethernet LAN (RJ-45) ports0
Full HDYes
Supported video modes1080i
Supported graphics resolutions1920 x 1080 (HD 1080), 800 x 600 (SVGA)
RMS rated power1 W
PlacementDesktop
Product typeStandard throw projector
Product colorBlack
Cable lock slot typeKensington
Power sourceAC
Power consumption (standby)0.47 W
Power consumption (typical)270 W
Noise level37 dB
Country of originChina
Noise level (economic mode)29 dB
Pallet width800 mm
Pallet height2204 mm
Pallet length1200 mm
Pallet width (UK)1000 mm
Quantity per pack1 pc(s)
Quantity per pallet78 pc(s)
Quantity per pallet layer6 pc(s)
Weight and Dimensions IconWeight and Dimensions
Depth228 mm
Width295 mm
Height77 mm
Weight2300 g
Package depth360 mm
Package width335 mm
Package height158 mm
Package weight3320 g

Related product manuals