Epson EcoTank ET-3800 Series - Page 192

7.
Close the screen.
e screen automatically closes aer a specic length of time.
Note:
If connection fails, restart the wireless router, move it closer to the printer, and try again. If it still does not work, print a
network connection report and check the solution.
8.
Press the
button.
Related Information
& “Checking the Network Connection Status” on page 197
Making Wi-Fi Settings by PIN Code Setup (WPS)
You can automatically connect to a wireless router by using a PIN code. You can use this method to set up if a
wireless router is capable of WPS (Wi-Fi Protected Setup). Use a computer to enter a PIN code into the wireless
router.
1.
Select on the home screen.
To select an item, use the
u d l r buttons, and then press the OK button.
2.
Select Wi-Fi (Recommended).
If the printer has already been connected by Ethernet, select Router.
3.
Press the OK button.
If the network connection is already set up, the connection details are displayed. Select Change Settings to
change the settings.
If the printer has already been connected by Ethernet, select Change to Wi-Fi connection., and then select Ye s
aer
checking the message.
4.
Select Others > PIN Code Setup (WPS).
Adding or Replacing the Computer or Devices > Re-setting the Network Connection > Making Wi- …
192