Solving Screen Mirroring Problems
88
Check the solutions in these sections if you have any problems with Screen
Mirroring projection.
gg Related Links
• "Solving Screen Mirroring Connection Problems" p.88
• "Adjusting an Image that Contains Noise or Static in Screen Mirroring
Projection" p.88
Solving Screen Mirroring Connection Problems
If you are unable to connect to the projector using Screen Mirroring, try the
following solutions:
a
Check the projector's settings.
• Select On as the Screen Mirroring setting.
s Settings > Operation > Screen Mirroring
• Change the Display Name so that it does not include "-" or it may
not be displayed correctly on your mobile device.
s Settings > Operation > Screen Mirroring Settings > Display
Name
• Select Off as the Screen Mirroring setting, and select On again.
• Change the Operation Mode setting and connect again.
s Settings > Operation > Screen Mirroring Settings > Operation
Mode
• Make sure that the no other devices are connected to the projector
with the Interrupt Connection settings.
s Settings > Operation > Screen Mirroring Settings > Extended >
Interrupt Connection
• Change the Channel setting according to the wireless LAN
environment.
s Settings > Operation > Screen Mirroring Settings > Extended >
Channel
b
Check the mobile device's settings.
• Make sure the settings on the mobile device are correct.
• When connecting again immediately after disconnecting, it may take
some time until the connection is established. Reconnect after
waiting for a while.
• Restart the mobile device.
• Once you have connected using Screen Mirroring, the projector
connection information may be recorded on the mobile device.
However, you may not be able to reconnect to the projector from the
recorded information. Select the projector from the list of available
devices.
Adjusting an Image that Contains Noise or Static in
Screen Mirroring Projection
If the projected image or sound contains static when connecting using Screen
Mirroring, try the following solutions:
a
Check the mobile device's settings.
• Avoid covering the Wi-Fi antenna of the mobile device.
• If you use a Screen Mirroring connection and an internet connection
at the same time, the image may stop or contain noise. Disconnect
the internet connection to expand your wireless bandwidth and
improve the connection speed of the mobile device.
• Depending on the settings of the mobile device, the connection may
be lost when the device enters power saving mode. Check the
electrical power saving settings on the mobile device.
• Update to the latest version of the wireless driver or firmware on the
mobile device.
b
Make sure the projection contents meet the Screen Mirroring
requirements.
To Next Page
Loading...
