33
Configuration Menu Functions
Configuration Menu
This reduces the noise which can be generated around the edges of images when projecting MPEG
images. Three modes are available. Select your preferred mode.
Set to "ON" to reduce block noise which can occur when projecting MPEG images which have been
compressed at a low bit rate.
(This can be set when NTSC
signals are being input from the [Video] / [S-Video] input ports, or when
component video signals are being input from the [Component] input port.)
If using products designed for destinations such as South Korea that have different black level (setup
level) settings, use this function to obtain correct images. Check the specifications of the connected
equipment when changing this setting.
(
Setting is only possible when Color Mode is "Natural", "Cinema Night", "HD", or "Silver Screen", and
composite video, S-video, or component video signals are being input.)
If bright white areas of images such as clouds and T-shirts on the beach in summer appear uneven and
overexposed, set to "On". When set to "On", the "HDMI Video Range" setting will be ignored.
(Setting is not possible when composite video
, S-Video , or computer signals are being input.)
This changes the display area (the part of projected images).
• Off, 2%, 4%, 6%, 8%: If set to "Off", the top and the bottom of the image are sometimes affected by
electrical interference depending on the image signal. In such cases, try to
adjust the display position ("Position"). p.32
• Auto: Displayed when the signals from
[HDMI1] / [HDMI2]
input port are being input.
This is
automatically set to Off or 8%, depending on the input signal.
(Not displayed when the
equipment's DVI port is connected to the projector's
[HDMI1] / [HDMI2]
input port.)
(Setting is possible only when "EPSON Super White" is "Off". Setting is not possible, however, when
"Color Mode" is set to "x.v. Color.")
When the [HDMI1] / [HDMI2] input port of the projector is connected to a DVD player, for example,
setting this to Auto allows the projector to automatically determine and set the video range of the input
signal.
If this is set to Auto and a blackout/whiteout condition occurs, set the video range of the projector to
match that of the DVD player. The setting on the DVD player can be either Normal or Expand.
Note that if the equipment's DVI port is connected to the projector's [HDMI1] / [HDMI2] input port,
Auto is not displayed.
All the adjustment values on the "Signal" menu, except "Aspect
", are returned to their default values.
Displayed for input sources other than computer image
Mosquito NR
Block NR
Setup Level
*1
EPSON Super White
*1
Overscan
*1
HDMI Video Range
*1
Reset
*1 The setting values are stored separately for each image source and signal type.
To Next Page
Loading...
Need help?
General
