36
Configuration Menu Functions
"Memory" menu
"Reset" menu
This recalls the stored memory settings and your memory setting saved at "Save Memory". p.24
This can be used to save "Image" menu settings. p.24
This is used to erase unwanted memory setting saved as "Memory9" and "Memory10". p.25
This can be used to change the names of the memories from "Memory9" to "Memory10". You can
rename so that its settings are easy to recognize. Either of the following two methods can be used to
change a memory name. p.25
• Select a new memory from the list and then rename it.
• Select "Customized" and then enter a desired name.
This resets all configuration menu settings to their default settings. "Component" and "Language" in the
"Settings" menu, and the settings of "Memory" menu are not returned to their default even if "Reset All"
is executed.
This resets (erases) all settings that have been made using the "Save Memory".
A locked memory cannot be initialized.
Clear the cumulative lamp operating time and reset to "0H". Perform this procedure when you replace
the lamp.
Load Memory
Save Memory
Erase Memory
Rename Memory
Reset All
Reset Memory
Reset Lamp Hours
To Next Page
Loading...
Need help?
General
