What to do if Epson Home Theater System shows a high temp warning?
If you receive a high temperature warning on your Epson Home Theater System, you can continue projecting. If the temperature rises too high again, projection will stop automatically. Ensure there is at least 20 cm between the wall and the projector's exhaust vent if it's installed next to a wall. Also, clean the air filter if it's clogged.
What to do if Epson Home Theater System shows internal error?
If your Epson Home Theater System displays an internal error, remove the power plug from the electrical outlet and contact your local dealer or the nearest Epson repair center.
General| Matrix size | 0.61 \ |
|---|---|
| Projection distance | 2.95 - 4.8 m |
| Projection technology | LCD |
| Contrast ratio (typical) | - |
| Screen size compatibility | - \ |
| Projector native resolution | 1080p (1920x1080) |
| Keystone correction, horizontal | ± 30 ° |
| Aspect ratio | 16:9 |
| RS-232 ports | 1 |
| Connectivity technology | Wired |
| Focal length range | 18.2 - 29.2 mm |
| Aperture range (F-F) | 1.51 - 1.99 |
| Lamp type | UHE |
| Lamp power | 230 W |
| Light source type | Lamp |
| Service life of light source | 5000 h |
| DVI port | No |
| AC (power) in | Yes |
| USB connector type | USB Type-A |
| Serial interface type | RS-232 |
| USB 2.0 ports quantity | USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them. |
| S-Video inputs quantity | 0 |
| Supported video modes | 1080p |
| Supported graphics resolutions | 1920 x 1080 (HD 1080) |
| RMS rated power | 20 W |
| Product color | Black |
| Market positioning | Home cinema |
| Power source | AC |
| AC input voltage | 100 - 240 V |
| Voltage tolerance | 10 % |
| AC input frequency | 50 - 60 Hz |
| Power consumption (standby) | - W |
| Power consumption (typical) | 274 W |
| Noise level | - dB |
| Noise level (economic mode) | 24 dB |
Weight and Dimensions| Weight | 6000 g |
|---|
To Next Page
