What to do if Epson EH-TW6300 shows High Temp Warning?
The 'High Temp Warning' indicates that the projector's temperature is rising. You can continue projecting, but if the temperature rises too high again, projection will stop automatically. Ensure there is at least 20 cm between the wall and the Epson Projector's exhaust vent if it's installed next to a wall. Also, check if the air filter is clogged and clean it if necessary.
General| Contrast Ratio | 70, 000:1 |
|---|---|
| Projection Technology | 3LCD |
| Throw Ratio | 1.32 - 2.15:1 |
| Zoom Ratio | 1.6x |
| Lens Shift | Vertical: ±60%, Horizontal: ±24% |
| 3D | Yes |
| Resolution | 1920x1080 (Full HD) |
| Brightness | 2500 lumens |
| Lamp Life | 5, 000 hours (Eco) |
| Projection Size | 30 - 300 inches |
| Input Ports | Component, Composite |
Details the names and functions of the projector's physical components.
Provides instructions and guidance on how to install the projector.
Step-by-step instructions on how to project images onto a screen.
Procedures for safely turning off the projector.
General procedures for adjusting focus, size, and test patterns.
Methods for correcting keystone and lens shift distortions.
How to select color modes for optimal image quality.
Detailed color adjustments including temperature, RGB, hue, saturation.
Information and setup procedures for viewing 3D content.
Setup and operation for WirelessHD devices and transmitters.
How to use the HDMI Link feature for device control and synchronization.
How to project images over a wired network connection.
How to project images over a wireless network connection.
How to navigate and use the projector's configuration menus.
Settings for configuring wired and wireless network connections.
General guidance and steps for resolving projector issues.
Understanding projector status indicators during errors and normal operation.
Troubleshooting common issues with projected images like no image or color errors.
Troubleshooting problems with projector startup and remote control response.
Step-by-step guides for replacing the projector's lamp and air filter.
To Next Page
