Color Difference Correction when Projecting from Multiple Projectors
73
The current Projector ID is displayed on the projected screen. It
disappears after about 3 seconds.
b
While holding the [ID] button, press the number button that matches
the ID of the projector you want to operate.
The projector you want to operate is selected.
a
• When you select [0/All] on the remote control, you can
operate all projectors regardless the Projector ID setting.
• When you set the Projector ID setting to Off, you can operate
the projector using the remote control whichever ID you select
on the remote control.
• The projector ID setting is saved in the remote control. Even if
the remote control batteries are removed to replace them and
so on, the saved ID setting is retained. However, if the batteries
are left out of the remote control for an extended period, the
ID returns to its default setting (0/All).
• When you use multiple remote controls at the same time, you
may not be able to operate projectors as intended due to
infrared interference.
Matching Multiple-Projector Display Quality
You can match the display quality of multiple projectors that will project next
to each other.
a
Turn on all the projectors on which you want to match the display
quality.
b
Set ID numbers on each projector.
c
Make sure all the projectors are using the same Color Mode setting.
d
Select the remote control ID to match the first projector.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
