20cm
20cm
Page 16 of Instruction Manual
Adjust the distance between the projector and
the screen until the desired image size is obtained.
screen size
* When installing against a wall, leave a
space of about 7.87 inches (20cm) between
the projector and the wall.
projection distance
300"
200"
150"
120"
100"
80"
60"
40"
30"
28"
Setting Up
*
*
433.07
515.75inch (11.0
13.1m)
287.4
342.52 (7.3
8.7)
216.54
255.91 (5.5
6.5)
173.23
208.66 (4.4
5.3)
145.67
169.29 (3.7
4.3)
114.17
133.86
(2.9
3.4)
86.61
102.36
(2.2
2.6)
59.06
66.93
(1.5
1.7)
43.31
47.24
(1.1
1.2)
39.37 43.31
(1.0 1.1)
Operation Display indicator
Checking the Indicators
The projector is equipped with indicators that alert you to problems with projector operation.
The following tables show what the indicators mean and how to remedy problems that they indicate.
Problem/Alarm Display indicator
Troubleshooting
Standby condition
This is the only time when the power
cord can be disconnected.
Projection starts when the is
pressed.
Cool-down in progress
After approximately 2 minutes, the projector
switches to the standby condition
(the indicator lights orange).
Projecting in progress
Warm-up in progress
After warm-up is complete, projection
will start when a video signal is input.
Indicator status
Problem and remedy
Lights
orange
Flashes
orange
Lights
green
Flashes
green
Off
Power is not turned on
*1
If an indicator is showing a status which does not appear in the previous
tables, contact your dealer or the nearest address provided at "International
Warranty Conditions" in "Safety Instructions/World-Wide Warranty Terms"
included in the package.
*2
Contact your dealer for a spare lamp.
Indicator status
Problem and remedy
High temperature inside projector (overheating).
The lamp will turn off automatically and
projection will stop. Wait for about 5 minutes
without operating the projector. After 5 minutes
have elapsed, disconnect the power plug and
re-insert it. After re-inserting it, press the to
turn the power back on.
Remove the lamp and check if it is broken.
If the lamp is not broken, reinstall it.
If the lamp is broken, replace it with a
new lamp.*2
High-speed cooling in progress.
If the internal temperature rises any higher,
projection will stop.
Check that the air inlet and exhaust vents are clear
and that the indoor temperature is not too high.
Internal problem
Stop using the projector and ask for
projector to be repaired. *1
Flashes
orange
Lights red
Off
Flashes red
(1-second
intervals)
Flashes red
(2-second
intervals)
Lamp abnormality.
Operating normally.
(Operation Display) indicator
(Problem/Alarm Display) indicator
Pages 54-56 of
Instruction Manual
To Next Page
Loading...
Need help?
General
